Journal of Prosthetic Dentistry
Volume 89, Issue 6 , Pages 565-571 , June 2003

The retention of complete crowns prepared with three different tapers and luted with four different cements

  • Omar Zidan, BDS, HDD, MS, PhD

      Affiliations

    • Department of Restorative Sciences, Minneapolis, Minn, USA
    • Corresponding Author InformationReprint requests to: Dr Omar Zidan, School of Dentistry, University of Minnesota, 8-450 Moos Tower, 515 Delaware St. SE, Minneapolis, MN 55455, USA, Fax: (612) 625-7440
    • ,
  • Gary C Ferguson, DMD, MS

      Affiliations

    • Private Practice, Waterville, Me, USA

References 

  1. Jorgensen KD. The relationship between retention and convergence angle in cemented veneer crowns. Acta Odontol Scand. 1955;13:35–40
  2. el-Ebrashi MK, Craig RG, Peyton FA. Experimental stress analysis of dental restorations. IV. The concept of parallelism of axial walls. J Prosthet Dent. 1969;22:346–353
  3. Kaufman EG, Coelho DH, Colin L. Factors influencing the retention of cemented gold castings. J Prosthet Dent. 1961;11:487–502
  4. Goodacre CJ, Campagni WV, Aquilino SA. Tooth preparations for complete crowns (an art form based on scientific principles). J Prosthet Dent. 2001;85:363–376
  5. Oilo G, Jorgensen KD. The influence of surface roughness on the retentive ability of two dental luting agents. J Oral Rehab. 1978;5:377–389
  6. Rosenstiel SF, Fujimoto J, Land MF. In: Contemporary fixed prosthodontics. 3rd ed. St Louis: Mosby; 2001;p. 81–85
  7. Rosenstiel SF, Land MF, Crispin BJ. Dental luting agents (a review of the current literature). J Prosthet Dent. 1998;80:280–301
  8. Creugers NH, Kayser AF, van’t Hof MA. A meta-analysis of durability data on conventional fixed bridges. Community Dent Oral Epidemiol. 1994;22:448–452
  9. Wilson AD, McLean JW. Glass-ionomer cement. Chicago: Quintessence; 1989, p. 85-7
  10. Metz JE, Brackett WW. Performance of a glass ionomer luting cement over 8 years in a general practice. J Prosthet Dent. 1994;7:13–15
  11. Gorodovsky S, Zidan O. Retentive strength, disintegration, and marginal quality of luting cements. J Prosthet Dent. 1992;68:269–274
  12. Nakabayashi N, Masuhara E. Development of adhesive pit and fissure sealants using a MMA resin initiated by a tri-n-butyl borane derivative. J Biomed Mater Res. 1978;12:149–165
  13. Tanaka T, Nagata K, Takeyama M, Atsuta M, Nakabayashi N, Masuhara E. 4-META opaque resin— a new resin strongly adhesive to nickel-chromium alloy. J Dent Res. 1981;60:1697–1706
  14. Chang JC, Hurst TL, Hart DA, Estey AW. 4-META use in dentistry (a literature review). J Prosthet Dent. 2002;87:216–224
  15. Wada T. In: Development of a new adhesive material and its properties in adhesive prosthodontics. 1st ed. Nijmegen, The Netherlands: Eurosound Drukkerij BV; 1986;p. 9–20
  16. Black SM, Charlton G. The retention of gold crowns on human dentine preparations—a comparison of eight cements. Restorative Dent. 1989;5:39–41
  17. Ayad MF, Rosenstiel SF, Salama M. Influence of tooth surface roughness and type of cement on retention of complete cast crowns. J Prosthet Dent. 1997;77:116–121
  18. Mojon P, Hawbolt EB, MacEntee MI, Ma PH. Early bond strength of luting cements to a precious alloy. J Dent Res. 1992;71:1633–1639
  19. Tjan AH, Li T. Seating and retention of complete crowns with a new adhesive resin cement. J Prosthet Dent. 1992;67:478–483
  20. Wilson AH, Chan DC. The relationship between preparation convergence and retention of extracoronal retainers. J Prosthodont. 1994;3:74–78
  21. Mack PJ. A theoretical and clinical investigation into the taper achieved on crown and inlay preparations. J Oral Rehabil. 1980;7:255–265
  22. Leempoel PJ, Lemmens PL, Snoek PA, van’t Hof MA. The convergence angle of tooth preparations for complete crowns. J Prosthet Dent. 1987;58:414–416
  23. Kent WA, Shillingburg HT, Duncanson MG. Taper of clinical preparations for cast restorations. Quintessence Int. 1988;19:339–345
  24. Nordlander J, Weir D, Stoffer W, Ochi S. The taper of clinical preparations for fixed prosthodontics. J Prosthet Dent. 1988;60:148–151
  25. Annerstedt A, Engstrom U, Hansson A, Jansson T, Karlsson S, Liljhagen H, et al.  Axial wall convergence of full veneer crown preparations. Documented for dental students and general practitioners. Acta Odontol Scand. 1996;54:109–112
  26. Smith CT, Gary JJ, Conkin JE, Franks HL. Effective taper criterion for the full veneer crown preparation in preclinical prosthodontics. J Prosthodont. 1999;8:196–200
  27. Walton JN, Gardner FM, Agar JR. A survey of crown and fixed partial denture failures (length of service and reasons for replacement). J Prosthet Dent. 1986;56:416–421
  28. Rosenstiel SF, Gegauff AG. Improving the cementation of complete cast crowns (a comparison of static and dynamic seating methods). J Am Dent Assoc. 1988;117:845–848
  29. Zwillinger D, editor. CRC standard mathematical tables and formulae. 31st ed. Boca Raton (FLA): CRC Press. 2003. p. 312

PII: S0022-3913(03)00182-3

doi: 10.1016/S0022-3913(03)00182-3

Journal of Prosthetic Dentistry
Volume 89, Issue 6 , Pages 565-571 , June 2003

Article Tools

* Image Usage & Resolution